Why does motion sensor switch turn light on immediately after switching off? - motion sensor switch
I installed a motion sensor switch standard. The lights illuminate when the device to go with the switch after its proposal in the amount of time the lights sent. (So far so normal).
BUT ... when the lights go back right (within 2 seconds). This is done continuously, without end.
I:
replaced by a new change, and had the same results.
the tape to the "eye" placed on the market, so that no motion / heat can be detected, and the same results.
Somebody out there has ideas?
* Note: This sensor contains no day / night switch, so the problem can not connect with this.
Sunday, January 10, 2010
Motion Sensor Switch Why Does Motion Sensor Switch Turn Light On Immediately After Switching Off?
1 comment:
Most of these fires were built in test mode .... If you are off the wall switch and then connect to describe the switch test mode and function as you. The amendment should restore back to normal operation. When the switch to "ON" leave it there. Also in the motion, there is a switch on the underside of the tester. Follow the instructions of the manufacturer and should be ok.
Post a Comment